Er det noen som har koblingsjema til en sparkrite electronic ignition mk2 sx2000 el om det er noen som husker hvordan den kobles? Fargene på ledningene er rød/blå på samme kontakt en hvit en lilla og en grønn ledning.
hei, har samme problen som deg. fått svar?
Vil svært gjerne koble opp min sparkrite til min Amazon. hadde denne i en annen Amazon for 20 år sia.. håper på positivt svar
Rune
Hi !
I have a Sparkrite SX2000 electronic ignition, and the wiring is as follows:
Green - earth (negative)
Red + Blue - +12V
Purple - to coil -ve or CB connection
White - to the contact breaker wire from the distributor
The units are only for negative earth only (as far as I know).
The Red and blue wires can normally be connected to the +12V side of the coil if there is a spare terminal, and the original feed wire from the ignition is left connected.
The existing wire from the distributor contact breaker that is connected to the coil -ve connection is disconnected. This wire then connects to the white wire from the Sparkrite unit. The purple wire from the Sparkrite unit connects to the coil -ve terminal instead of the original wire that is now connected to the white wire from the Sparkrite.
The green wire connects to an earth connection - usually one of the bolts that holds the coil onto the engine.
I'm not sure if the wires on the TX2000 are different from the unit I have, but I hope this helps.